

Service Clients à votre écoute Devis gratuits sur simple demande TEL: 07 60 18 07 69 /06 61 22 77 61
Utilisez ce câble pour raccorder une batterie compatible avec un Bus CAN , ne provenant pas de chez Victron, à un système Victron. Il y en a de deux types – A et B. Voir le manuel ci-dessous pour savoir avec plus de détails quel câble doit être utilisé en fonction de la marque des batteries.
VE.Can to CAN-bus BMS cables manual
Use these VE.Can to CAN-bus cables to connect a CAN-bus enabled battery to a GX device.
1. Selecting the right cable
ASS030710018 - VE.Can to CAN-bus BMS type A Cable 1.8m
§ BYD B-Box
§ Pylontech US2000C/US3000C/Force-L
ASS030720018 - VE.Can to CAN-bus BMS type B Cable 1.8m
§ LG Chem Resu
§ AXIstorage
§ BMZ
§ Pylontech US2000/US3000/UP2500
2. Installation
The side labeled 'CAN-bus BMS' plugs into the battery. The other side, labeled 'VE.Can' must be plugged into either the VE.Can port of the GX device, or the BMS-Can port.
Both port types (VE.Can and BMS-Can) on a GX Device can be configured for use with a CAN-bus BMS connected third party battery.
For configuration, see the manual specific to the brand of battery you are using.
3. Pin-out
In some cases it might be needed to make the cable at the location. Find below the pin-outs. Make sure to very carefully test the cable after crimping it. Self-made cables are very often the causes of very hard to diagnose problems.
3.1 Type A
Function |
Victron VE.Can side |
Battery side |
GND |
Pin 3 |
Pin 6 |
CAN-L |
Pin 8 |
Pin 5 |
CAN-H |
Pin 7 |
Pin 4 |
3.2 Type B
Function |
Victron VE.Can side |
Battery side |
GND |
Pin 3 |
Pin 2 |
CAN-L |
Pin 8 |
Pin 5 |
CAN-H |
Pin 7 |
Pin 4 |